Footplate Adjustment - progeo JOKER EVOLUTION User Manual

Front height adjustment :
This adjustment is necessary in order to obtain the correct height of
the front of the wheelchair.
The front height of the wheelchair depends on the dimensions
of the front wheel and on the size of the fork, but also on the
position of the fork support "S".
In fact, this support can slide up or down along the frame
(figure 49).
Loosen the headless bolt "G" (2.5mm Allen key)
Loosen the fixing bolts and nuts "D1" and "D2".(4mm
Allen key and 10mm spanner)
Slide the support "S" to the desired height
Tighten all bolts and nuts.
Repeat the same operation on both forks.
The front height can also be changed by fixing the wheel in
a different pre-drilled holes on the fork.
Remove screws "F" (using a 4 mm Allen key)
Move the wheel to a different position
Replace screws and tighten firmly.
Repeat the same operation on both forks.
The adjustment of the front height becomes necessary
when the front wheels are replaced with bigger or
smaller ones or simply because the user wishes to
modify the front height of the wheelchair.
Every time the height is adjusted it is also necessary
to check and adjust the angle (see angle adjustment
instruction at the beginning of this chapter)
With carbon fiber frame do not tighten the headless
bolt "G" too hard, this may cause serious damage
the carbon fiber.
6.7

Footplate adjustment

Height adjustment : this adjustment serves to vary the distance of
the footrest from the seat to enable the correct sitting position of the
user based on the height of the user and his/her leg length.
Fig.49
JOKER EVOLUTION 32