Handling The Camera; Charging The Battery; General; Using The Combined Power Supply And Battery Charger To Charge The Battery When It Is Inside The Camera - FLIR T4 series User Manual

13

Handling the camera

13.1 Charging the battery

Note You must charge the battery for 4 hours before you start using the camera for the
first time.

13.1.1 General

You must charge the battery when a low battery voltage warning is displayed on the
screen.
Follow one of these procedures to charge the battery:
• Use the combined power supply and battery charger to charge the battery when it is
inside the camera.
• Use the combined power supply and battery charger to charge the battery when it is
outside the camera.
• Use the stand-alone battery charger to charge the battery.
13.1.2 Using the combined power supply and battery charger to charge the
battery when it is inside the camera
Note For brevity, the 'combined power supply and battery charger' is called the 'power
supply' below.
13.1.2.1 Procedure
Follow this procedure:
1. Open the battery compartment cover.
2. Connect the power supply cable plug to the connector on the battery.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 16.
13.1.3 Using the combined power supply and battery charger to charge the
battery when it is outside the camera
Note For brevity, the 'combined power supply and battery charger' is called the 'power
supply' below.
13.1.3.1 Procedure
Follow this procedure:
1. Put the battery on a flat surface.
2. Connect the power supply cable plug to the connector on the battery.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 16.

13.1.4 Using the stand-alone battery charger to charge the battery

13.1.4.1 Procedure
Follow this procedure:
1. Put the battery in the stand-alone battery charger.
#T559879; r. AP/36066/36066; en-US
22