Table of Contents
Advertisement
•
!
LOWER _NEL,
if_u
OVEN BOTTOM
i
!
i
i
_
,
i
Protectthe oven bottom against excessive spillovers,
Ranges that do not feature a lowerbroiling compartment
especially acid or sugaryspillovers, as they may discolor
will have a panel in place of the broiler door. This panel
the porcelain.Use the correct size cooking utensil to avoid
must be removed to access the ratingplate located on the
boilovers. Never place utensils or aluminumfoil directly on
lower range front frame. The rating plate containsthe
the oven bottom,
model and serial numbers for your appliance.
To remove panel: Grasp the bottom corners of the panel.
'1'_
Then lift the panel up and away from the range.
To replace panel: Align the four slots on the panel with
.
the four screwson the rangefront frame. Then lowerthe
_
2
panel and push down until the panel snaps into place.
.......
....
_..
Some floors are not level. For _
proper baking, your range
must be level. Leveling legs
To remove: When cool, removethe oven racks. Slide the
are located on each corner at
two catches, locatedat each rear corner of the oven
the base of the range. Level by
bottom,towardthe front of the oven. Lift the rear edge of
turning the legs.
)_)
the oven bottom slightly.Then slide it back until the front
edge of the oven bottom clears the oven front frame.
Removethe oven bottomfrom the oven.
To prevent rangefrom accidentlytipping, range should be
securedto the floor by sliding a rear leveling leg intothe
To replace: Fit the front edge of the oven bottom into the
anti-tip bracket suppliedwith the range.
front frame. Lowerthe rear of the oven bottom and slide
the two catches back to lock the oven bottom into place.
ELECTR_
CONNECTION
:
,
Applianceswhich require electrical power are
STORAGE DRAWER
equipped with a three-prong grounding plug which
The storage drawer at the bottom of the range is safe and
must be plugged directly into a properly grounded
convenientfor storing metal and glass cookware. DO
three-hole 120 volt electrical outlet.
NOTstore plastic, paperware,food or flammable material
in this drawer. Removedrawer to clean under range.
I_
Always disconnect power to appliance before servicing.
To remove: Pull drawer out to the first stop position. Lift
The three-prong grounding plug offers protection against
upfront of drawer and pull to the secondstop position,
shock hazards. DO NOT CUT OR REMOVETHE THIRD
Grasp sides and lift up and out.
GROUNDINGPRONG FROM THE POWER CORD
PLUG.
To replace: Fitthe rollerslocatedat theendsof the
drawerglides intothe railsonthe range.Liftup drawer
Ifan ungrounded, two-holeor othertypeelectricaloutletis
front and gently push in to first stop position.Lift up
encountered,it is the personal responsibility of the
drawer again and continueto slide drawer to the closed
appliance owner to have the outlet replaced with a
position,
properly groundedthree-hole electrical outlet.
Advertisement
Table of Contents
