Care And Maintenance - Sartorius Entris Operating Instructions Manual

Care and Maintenance

Service
On request, Sartorius can offer you an individual service contract.
Repairs
Repair work must only be carried out by trained service technicians. Repairs
performed by untrained persons may result in considerable hazards for the user.
Cleaning
Unplug the AC adapter from the wall outlet (mains supply). If you have an interface
cable connected to the balance port, unplug it from the port.
Make sure that no liquid enters the balance housing.
t Clean the balance with a cloth lightly moistened with soap solution.
y The plastic top and bottom parts of the balance housing have a special coating
that allows acetone to be used to clean these parts.
Do not clean the following parts with acetone or aggressive cleaning agents:
foil-covered keypad, power connector port, data interface, or any other plastic
parts.
t Wipe the balance with a soft, dry cloth.
36
On analytical balances remove and clean the weighing pan
as follows:
Reach beneath the shield disk and lift it up
carefully together with the weighing pan to avoid
damaging the weighing system.
Make sure that no liquid enters the balance
housing.
Cleaning Stainless Steel Surfaces
Clean all stainless steel parts regularly. Remove the
stainless steel weighing pan and thoroughly clean it
separately. Use a damp cloth or sponge to clean stainless
steel parts on the balance.
You can use any household cleaning agent that is suitable
for use on stainless steel. Clean stainless steel surfaces
only by wiping them down. Then rinse the equipment
thoroughly, making sure to remove all residues.
Afterwards, allow the equipment to dry. If desired, you can
apply oil to the cleaned surfaces as additional protection.