Tadiran Telecom TGW4 SERIES User Configuration Manual page 41

TGW4/8 Gateway Series for Aeonix
Name
Release
control by
caller
Loop open
disconnect
RFC6913
Get CPN from
Registration
subscription
Call waiting
*
Call hold
*
Call transfer
by calling
party
*
Caller ID
delivery
Caller ID
restriction
Outgoing call
barring
DND
allowance
Three-way
calling
Tadiran Telecom (TTL) L.P.
Description
Select if the call release is controlled by the caller. By default, this is not selected.
Selected: the gateway will immediately release the call upon caller hanging up; the
gateway will not release the call after the called party hung up as long as the caller is still
off-hook until timeout (60 sec by default);
Cleared: the gateway will immediately release the call upon either party hanging up the
call.
Select it only if the trunk of the PBX supports loop open signaling, in which
the PBX takes the loop open as the indication of disconnection. Select it only if the trunk
of the PBX supports loop open signaling, in which
the PBX takes the loop open as the indication of disconnection.
Note: Loop open interval can be configured on the Advanced > Line page.
If this item is selected, the Fax over IP label carried in INVITE is supported.
If a received INVITE message carries From and P-Asserted-Id header fields, the caller
identification number will be selected according to this parameter.
If the received INVITE message does not carry the P-Asserted-Id header field, caller
identification numbers are obtained from the From header field.
P-Asserted-Id field preferentially: The caller identification information is

preferentially obtained from the P-Asserted-Id field in the INVITE message.
From field only: The caller identification information is obtained from the From field

in the INVITE message.
From field only is selected by default.
The TGW subscribes the registration status of the line. If the subscription is successful,
the SIP server sends a NOTIFY message for notification of the registration status of the
line.
Select if Call waiting is activated on this line. By default this is not selected.
Select it to enable Call Hold on this line. By default this is not selected.
Note: If this function is enabled, the gateways will automatically activate Call Transfer.
For Aeonix US ALARMS (with 2-way Digital Receivers)  Select the Call hold check box.
Select if Caller Transfer is activated on this line. By default, this is not selected. When A
calls B, B picks up the call and A transfers the call to C.
Note: The call hold must be activated before caller transfer.
For Aeonix US ALARMS (with 2-way Digital Receivers)  Select the Call transfer
party
check box.
Set whether the calling number is sent to the called party. This feature requires the support
of Aeonix. By default this is selected.
For Aeonix US ALARMS 
use the default, do not select the Caller ID delivery check box (for all FXS lines).
Set whether the number of this telephone is sent to the called party with support from
platform. By default this is not selected.
Select if outgoing calls are barred on this line. By default, this is not selected.
Select if Do Not Disturb is allowed to be enabled on this line. By default, this is not
selected.
Select if 3-way service is activated. By default this is not selected.
Digital Receivers do not work well with Caller ID, therefore:
User Configuration Manual
by calling
29