Stanford Research Systems DS360 Operating Manual And Programming Reference page 62

4-4 Remote Programming
DPTH (?) x 4-15
NBCT (?) x 4-15
NRCT (?) x 4-15
BNDW (?) x 4-16
CENF (?) i 4-16
Setup Control Commands
*IDN? 4-17
*RCL i 4-17
*SAV i 4-17
KEYS (?) i 4-17
Status Reporting Commands
*CLS 4-18
*ESE (?) i 4-18
*ESR? {i} 4-18
*PSC (?) i 4-18
*SRE (?) i 4-18
*STB? {i} 4-18
DENA (?) i 4-18
STAT? {i} 4-18
Hardware Test and Calibration Commands
*TST? 4-19
$FCL 4-19
$FIL (?) n 4-19
$NOF (?) n 4-19
$PRE (?) n 4-19
$PST (?) n 4-20
$WRD (?) j,k 4-20
DS360 Ultra Low Distortion Function Generator
Sets Burst Depth to x; must include DB or PR (%).
Sets Noise Burst Count to x.
Sets Noise Rate Count to x.
Sets Noise BW to 100, 200, 400, 1.6k, 3.2k, 6.4k, 12.8k, 25.6k, 51.2k,
102.4k.
Sets BW Noise Center Frequency to x.
Returns the DS360 device identification string.
Recalls stored setting number i (0 to 9).
Saves the current instrument setting as setting number i (1 to 9).
Simulates the pressing of a front pannel key.
Clears all status registers.
Sets/Reads the Standard Event Status Byte Enable register.
Reads the value of the Standard Event Status register {or bit i only}.
Sets the value of the power on status clear bit.
Sets/Reads the Serial Poll Enable register.
Reads the value of the Serial Poll Byte {or bit i only}.
Sets/Reads the value of the DDS enable register.
Reads the value of the DDS register {or bit i only}.
Starts self test and returns status when done.
Recalls the factory calibration bytes.
Sets the State variable Filter to the n-th filter.
Sets the filter mode to n (0,1 or 2).
Sets the DS360 pre-amplifier attenuators to range n (0 to 31).
Sets the DS360 post-amplifier attenuators to range n (0 to3).
Sets the value of calibration word j to k.