Stanford Research Systems DS360 Operating Manual And Programming Reference page 102

6-8 Performance Tests
2. Self Tests
This test verifies that the DS360's memory and processors are functional.
Setup
No external setup is required.
Procedure
1) Turn on the DS360. The ROM firmware version number and the serial number should be
displayed for about 3 seconds. The self tests will execute and the message "Tests Pass" should
be displayed. If an error message appears, see the TROUBLESHOOTING section in Chapter 3
for a description of the error.
2) This completes the self tests. Enter the results of the test on the test record located at the end of
this section.
DS360 Ultra Low Distortion Function Generator