Modify Functions; Instrument Setup; Default Settings; Storing And Recalling Settings - Stanford Research Systems DS360 Operating Manual And Programming Reference

3-18 Operation

Instrument Setup

This section describes the DS360's default settings, storing and recalling settings, setting the computer
interfaces and running the self-tests.

Default Settings

Press [RCL][0] to recall the DS360's default settings. This is a good place to begin
whenever you wish to start the instrument from a known state. The default settings are
listed below. See Chapter 5 for information on the default settings for the digital output.
Modify Function On/Off
2-Tone Tone 1 Frequency
2-Tone Tone 2 Frequency
2-Tone Tone 1 Amplitude
2-Tone Tone2 Amplitude
Bandwidth Limited Noise Center Frequency
Bandwidth Limited Noise Bandwidth

Storing and Recalling Settings

Storing Settings
The DS360 can store up to 9 independent instrument setups in non-volatile RAM,
separate from the default settings ([RCL][0]). To store the current instrument setup, press
[STO] followed by a location number (1-9). After any of the units keys are pressed, the
DS360 Ultra Low Distortion Function Generator
Default Settings
Setting
Function
Frequency
Amplitude
Offset
Output On/Off
Output Type
Output Mode
Output Impedance
Modify Function
Start Frequency
Stop Frequency
Sweep Rate
Trigger Source
Burst Depth
Burst Count
Burst Rate
2-Tone Mode
GPIB Address
RS-232 Baud Rate
Default Value
Sine
1.00000 kHz
1.000 Vrms
0.00 V
DC
On
Unbalanced
Analog
Hi-Z
Linear Sweep
Off
1.000 Hz
100.000 kHz
1.0 kHz
Internal
50%
1
10
1.00000 kHz
10.0000 kHz
1 Vrms
1 Vrms
Sine-Sine
0 Hz
3.2 kHz
As set
As set