Stanford Research Systems DS360 Operating Manual And Programming Reference page 30

2-10 Basics
Parameter LEDs
These LEDs indicate which parameter is currently displayed in the parameter display.
Display LED
FREQ
AMPL
OFFSET
STARTF
STOPF
REL
TONE1
TONE2
DEPTH
COUNT
TRIGR
RATE
DS360 Ultra Low Distortion Function Generator
Parameter LEDs
Parameter
Output Frequency
Output Amplitude
Output Offset
Start Frequency for Sweeps
Center Frequency for Bandwidth Limited Noise
Stop Frequency for Sweeps
Cutoff Frequency for Bandwidth Limited Noise
Indicates that the amplitude display is in REL mode. Does not indicate a specific
display.
Indicates that Amplitude and Frequency Displays refer to TONE 1. Does not
indicate a specific display.
Indicates that Amplitude and Frequency Displays refer to TONE 2. Does not
indicate a specific display.
Off Level Depth for Bursts
Burst Count for Bursts
Trigger Source for Sweeps and Bursts
Burst Rate for Bursts