Figure 2-3 Keypad - Stanford Research Systems DS360 Operating Manual And Programming Reference

2-6 Basics
Keypad
FUNCTION OUTPUT
FREQ
WHT NOISE
PINK NOISE
AMPL
DIGITAL
2-TONE
(SHIFT)
OFFST
ON/OFF
Function Keys
These keys control the main function output. The [∧] up and [∨] down function keys
select between the main output functions. [FREQ], [AMPL] and [OFFST] select the
output frequency, amplitude and DC offset voltage. [ON/OFF] turns the output on and
off.
Output Selection Key
The [∨] key changes the output configuration from one of the three choices: unbalanced,
balanced and digital. Pressing the [∨] once moves one entry down the list; pressing the
[SHIFT](∧) moves one entry up the list.
Trigger Key
The [TRIGR] key begins singly triggered modified functions, like single sweeps or
bursts.
Modify Function Keys
These keys control the function output modification commands for sweeps, bursts or
bandwidth limited noise. The [∧] up arrow and [∨] down arrow keys select the
modification type. The [SWP/BURST] key turns the modification function on and off.
The other keys select different function modification parameters (start frequency, burst
depth).
Only modify functions that are allowable for the current function type (sine, square,
noise...) can be selected (i.e. sweep can be selected for sine or square, but not white
noise). Only modify parameters (START FREQ, STOP FREQ ...) that are valid for the
selected modify function can be changed. If a currently invalid modify parameter is
selected, the unit will beep and display "not APPL" (not applicable). If a function type
DS360 Ultra Low Distortion Function Generator
SECONDARY
SWP/BURST
UNBAL LIN SWP
ON/OFF
LOG SWP
BAL BURST
TRIG SRC
BW NOISE
START
CENTER
DEPTH
STOP
BW
BURST CNT
TRIGR RATE

Figure 2-3 Keypad

ENTRY
SHIFT
50 150
SHIFT STO RCL
F STEP F STEP ENA DIG FREQ
+/-
7 8
GPIB RS232 CAL
.
4 5
T2 MODE T1/T2 DIG 1
0 1 2
MODIFY
600 HI Z LOCAL
Vrms
CLR
%
# BITS DIG MODE
Vpp/DC
9
dB
SRQ DIG 0 DISP REL
dBm
6 REL
kHz
DIG 2 DIG 3
dBV
3
Hz