Rear Brake Installation - Argon 18 E-118 NEXT Assembly Manual

E-118 NEXT : 8. Rear brake installation
outer
side
GREASE
8.1 Remove the brake arm stopper (2i).
2i
8.2 Install the brakes* as shown in the
diagram.
- Install the spring (24d) in the middle
hole of the frame. To get more tension,
use the outer hole.
24d
2j+2k
*Please note that it is easier to install
GREASE
the drive side brake arm if you do it
before installing the crankset.
24j
24k
8.3 Install the brake arm stopper (2i)
24a
and adjust the set screw (24k) after
the wheel is put in place to avoid any
contact between the brake arm stopper
7Nm
and the crankset.
24b
- It is important not to mix the springs
of the front and rear brakes.
24i
- Respect the colour code: the spring
must be installed on the pivot of the
7Nm
same colour.
GREASE
24c
24h
The short end of the
spring must be
positioned in the
notch of the
8Nm
spring tensionner
8Nm
24