Intended Use; Exclusion Of Liability; Ec Conformity; Safety - Alpha-InnoTec LWC Series Operating Manual

Intended use

The unit may be used only for the intended purpose.
This means:
•
for heating.
•
for heating hot water.
The unit may be operated only within its technical
parameters.
Overview "Technical data / scope of delivery".
NOTICE.
Notify the responsible power supply company of
the use of a heat pump or heat pump system.

Exclusion of liability

The manufacturer will not be liable for damage resulting
from unauthorized use of the unit.
The manufacturer's liability will also be voided in the
following cases:
•
if work is performed on the unit and its
components in a manner that does not comply
with the terms of this operating manual;
•
if work is performed on the unit and its
components in an improper manner;
•
if work is performed on the unit that is not
described in this operating manual, and this work
was not expressly approved in writing by the
manufacturer;
•
if the unit or components in the unit are modified,
redesigned or removed without the express
written permission of the manufacturer.

EC conformity

The unit bears the CE mark of conformity.
EC declaration of conformity
4
Subject to change without notice | 83050400fUK – Translation into English of the original German operating manual | ait-deutschland GmbH

Safety

The unit is operationally safe when used for the intended
purpose. The construction and design of the unit
conform to the state of the art, all relevant DIN/VDE
regulations and all relevant safety regulations.
Every person who performs work on the unit must
have read and understood the operating manual prior
to starting any work. This also applies if the respective
person has already worked with such a unit or a similar
unit or has been trained by the manufacturer.
Every person who performs work on the unit must
comply with the applicable accident prevention and
safety regulations. This applies in particular to the
wearing of personal safety gear.
DANGER!
Danger of fatal injury due to electric
current!
Electrical connections may be installed
only by qualified electricians.
Before opening the unit, disconnect the
system from the power supply and secure
it from being switched back on!
WARNING!
Only qualified technicians (trained heating,
cooling, refrigerant and electrical techni-
cians) may perform work on the unit and
its components.
WARNING!
Unit contains refrigerants!
Leaking refrigerant
personal injury
Therefore:
– Shut down unit.
– Notify the manufacturer's authorized
service center.
ATTENTION
For safety reasons:
Never disconnect the unit from the power sup-
ply, unless the unit is being opened.
could result in
or material damage.