Grizzly G0733 Owner's Manual page 33

To outboard turn on the Model G0733:
1.
2.
3.
Figure 42
Figure 42. Lathe prepared for outboard turning.
4.
When outboard turning, ALWAYS use a floor
mounted tool rest and keep the tool in con-
tact with the rest during all turning opera-
tions. Failure to do so could cause the tool
to be pulled out of the operator's control
and ejected at high speed.
Sanding/Finishing
Figure 43
Figure 43.
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and may
cause
Never wrap sandpaper
or finishing materials
completely around the
workpiece.
serious injury.