Using Apply, Revert, And Default; Resetting The Appliance - VBrick 9000 Series Getting Started Manual

If the browser is closed after entering Edit mode, editing will not be ended. Therefore, a
second user can't know if the first user has simply forgotten to log off or is still engaged in
editing. After an hour of inactivity, Edit mode times out, whether the browser is open on the
desktop or closed without ending the Edit session. In VBAdmin, the
left side of the menu bar ends editing and logs you out of the application.

Using Apply, Revert, and Default

Depending on screen resolution, it may be necessary to scroll down the page to see additional
information and fields. The
the bottom of the page when appropriate. You may also see
and other buttons depending on what page you are on.
Apply Applies the changes made on the screen to the appliance. Note that these
changes will not be stored in the appliance's flash memory until you click
Save
Don't forget to save the configuration.
Revert Aborts all changes made on the screen and returns to the values that were
present prior to the first change that was made. Note that this only applies to
changes made prior to the last "apply."
Default Returns to the default settings for all parameters on the page. You must still
click
Clone
Finish Edit Ends the editing session and displays View mode.
Save

Resetting the Appliance

To reset the VBrick appliance do one of the following:

1. Power the VBrick appliance off and on by removing and reinserting the power cord.
2. Press the
Reset
available in
Edit
Note Some changes to the configuration will initiate an automatic reboot. When this
happens, wait approximately 60 seconds, then refresh the page and log back in with
your user name and password.
40
, and
Apply Revert
. This means if the appliance is powered down the changes will be lost.
for the settings to take effect.
Apply
button on the System Configuration > General page. This button is only
mode.
Logout
buttons however, are always shown at
Default
,
Clone Refresh
When configuring the Video Input on
multi–channel encoders, this button lets
you apply one set of configuration
parameters to one or more of the other
channels.
Writes all applied changes to Flash
memory. If you do not click Save after
editing, any changes you made are lost if
the appliance loses power or is reset.
© 2012 VBrick Systems, Inc.
button on the
, ,
Reset Counters