Fan Tray - VBrick 9000 Series Getting Started Manual

Color
Red
If a power supply fails, the LED will turn red and an alarm will sound. Push the alarm reset
button (the small black bubble button to the left of the left power cord receptacle) to silence
the alarm.
To remove/replace the power supply:

1. Turn off power to the power supply with switch at bottom and unplug power cord.
2. Pull unit out with handle while pressing the red release lever.
3. When replacing a power supply, push in firmly to seat firmly in backplane.
Figure 9. Dual Power Supplies

Fan Tray

The shelf has a common fan tray with four fans and a replaceable air filter. There are no
user-serviceable components in the fan tray. If an individual fan fails, you must replace the
entire unit or you will invalidate the shelf warranty. Contact VBrick for a replacement fan tray
as soon as possible. The
damaging the blades, do not run the shelf if more than one fan has failed. When you pull out the fan
tray, you can see the fans slowly spinning down. Any fan not spinning down has likely failed.
Table 15. Fan Tray LEDs
Color Description
Green Fan tray is good.
Red The fan tray has failed and should be replaced as soon as possible. Do not run
the shelf if more than one fan has failed or the tray been removed.
To remove/replace the fan tray:

1. Loosen the screws on each side of unit.
2. Press the
REQ
go from green to red and the
3. Remove the tray and determine how many fans have failed (see above). Do not run the
shelf if more than one fan has failed.
4. Contact VBrick for a replacement fan tray as soon as possible.
5. When powering down the fan tray to install a replacement, work quickly to avoid
overheating the blades.
24
Description
The power supply has failed.
LED will turn red if any of the fans has failed. To avoid
Status
(Request) button. This will power down the fan tray. The status LED will
LED will illuminate blue.
OK
© 2012 VBrick Systems, Inc.