VBrick 9000 Series Getting Started Manual page 61

Example 2
This example shows how to set the unicast
for Program1 and Transmitter1.
VBrick# svar vbrickProgramTransmitterInetAddrType.1=1
VBrick# svar vbrickProgramTransmitterInetAddr.1=172.22.118.105
VBrick# svar vbrickProgramTransmitterEnable.1=2
VBrick# svar vbrickProgramTransmitterApplySet.1=2
Scripting Syntax
• Script commands must start in column 1.
• (set variable) must precede the variable name.
svar
• Wait time is defined milliseconds. A value of 1000 = 1 second.
• Most variable changes require an
• There is no clear command.
• There is no chaining of scripts.
• Comments are not allowed on the same line as a command.
• Comments start with
• Blank lines are not allowed.
• All scripts are executed in a strictly serial manner by a single task.
• While executing a script it is possible to miss a double change of any event.
H.264 Encoding/Decoding Appliance Getting Started Guide
Destination IP Address
.
ApplySet
in column 1.
//
Command Line Interface
and enable the transmitter
51