Setting Vbrick Parameters - VBrick 9000 Series Getting Started Manual

Setting VBrick Parameters

Logging In
The first step is to connect to the VBrick appliance using whatever method is appropriate at
your site (e.g. Telnet, HyperTerminal, etc.). When logging in, you are prompted for a login
name and password. These credentials give you access to the VBrick and are typically
provided by an administrator. When the
logged in. The CLI shortcut commands are shown below.
Login: <username>
Password: <password>
VBrick#
Table 21. CLI Shortcut Commands
Command
BE
DEBUG
EE
ERRORS
GVAR
NT
QUIT
RESET
SAVE
SD
SFD
SVAR
WAIT
Beginning or Ending an Edit Session
To begin a CLI edit session, first login as explained above, and then enter the first two
commands shown below using the same username you used to login to the VBrick. You only need
to do this at the start of an edit session or if someone has ended your edit session. Also, you
only need to begin an edit session to set variable and table parameters—not to get parameters.
You can get parameters without starting an edit session. When your edit session is done, and
after you have applied or saved your changes, do an end edit. You can also use the Begin Edit
( ) and End Edit (
BE
To begin an edit session:

VBrick# SVAR vbrickEditName=
VBrick# SVAR vbrickEditName=<admin>
To end an edit session:

VBrick# SVAR vbrickEditName=
48
vbrick>
Description
Begin edit session
Generate a debug file if requested by VBrick Support Services.
End edit session
Show configuration errors
Get parameter
Ethernet Network Configuration
Logoff the CLI session
System reset
Save configuration
Set defaults
Set factory defaults
Set parameter
Delay for specified time
) shortcut commands shown in Table 21.
EE
prompt is displayed, you are successfully
© 2012 VBrick Systems, Inc.