VBrick 9000 Series Getting Started Manual page 26

Configuration > General page in VBAdmin. The backlight color of the LCD display will alert
you to configuration errors or warnings.
VBrick Systems
Release: x.x.x
Figure 6. Front Panel LCD (with Default Data)
The following table shows the sequence of messages displayed on the LCD panel. Note that
on encoder-only appliance models, you will see messages relevant to the encoder. On
decoder-only models you will see those relevant to the decoder. On combination models you
will see messages for the encoder followed by messages for the decoder. The LCD display
scrolls at the rate of one new message every three seconds. The basic sequence of messages is
shown in Table 8.
Note The first two messages in the front panel display are user-configurable and can be
modified (or hidden) on the System Configuration > General page in VBAdmin. See
the H.264 Encoding/Decoding Appliance Admin Guide for details.
Table 8. LCD Message Sequence
Sequence Message
1
VBrick Systems
Release x.x.x
IP xxx.xxx.xxx.xxx
Host Name/MAC Address
2
Edit Mode
3
Limited Run Mode
Video Input Problems
4
Program x (1–4)
Multicast
Unicast
Served
5
RX x Connected
Program Name
Output Format/Frame Rate
6
POST Errors
Table 9. Front Panel Backlight
State
Normal
Error
Warning
16
Description
Basic information (including user description, IP
address, host name/MAC address) is enabled by
default and always present unless disabled in
VBAdmin.
An Edit message is displayed when an Edit session
is in progress.
Warning messages are displayed if present.
Encoder messages are displayed if an encoder is
present. They show program information for each
configured transmitters and server.
Decoder messages are displayed if a decoder is
present. They show receiver connected, program
name, and output format/frame rate.
Error messages, if present, are shown last.
Backlight
Light Blue
Red
Yellow
© 2012 VBrick Systems, Inc.