VBrick 9000 Series Getting Started Manual page 77

Example 1
This example uses an external power source. Connect an external power supply (+8V to
+12V) and a switch directly to the ground pin and an event pin of the COM 2 port on the
appliance.
Example 2
This example uses the VBrick COM port output. Connect the COM output pin (COM2 pin1
RTS or COM2 pin2 DTR) through a switch to a COM event pin. For this method to work,
you must force the desired output pin (RTS or DTR) to
To force the desired output pin to On:

1. Go to the System Configuration > Advanced Configurations > Passthrough page in
VBAdmin.
2. Change
Passthrough State
3. Change
RTS/DTR Control
4. Change
Passthrough State
5. Click
Save Config
H.264 Encoding/Decoding Appliance Getting Started Guide
to and click Apply.
Responder
to and click Apply.
Force On
to and click Apply.
Disabled
when done.
VBrick 9000 Series Reference
using VBAdmin:
On
67