Unpacking - Ingersoll-Rand UP6 15 Operation And Maintenance Manual

NOTES
1. Coolant (lubricant) fill quantity (approximate) 3.4 US gallons (13
liters).
2. Recommended clearance in front of control panel door 42 inches
(1067 mm) or minimum as required by the latest national electrical
codes (NEC) or applicable local codes.
3. Recommended clearances on left and right sides 36 inches
(914mm).
4. Minimum recommended clearance for the rear of the compressor
is to be 6 inches (152mm).
5. External piping shall not exert any unresolved moments or forces
on the unit. Use pipe size as large or larger at discharge connection.
6. There should be no plastic or pvc piping attached to this unit or used
for any lines downstream.
7. Any field installed ducting to and from the compressor cannot add
more than 1/2" (12.5mm) water gauge total air resistance.
8. Do not pipe into a common header with a reciprocating compressor,
unless the reciprocating compressor utilizes a discharge pulsation
damper.
9. Sizing of electrical components not supplied by Ingersoll Rand is the
responsibility of the customer and should be done in accordance with
the information on the compressor data plate and national and local
electrical codes.
INSTALLATION / HANDLING
NOTE
All dimensions are in millimeters (inches) unless otherwise stated.
Ensure that the correct fork lift truck slots or marked lifting points are
used whenever the machine is lifted or transported.

UNPACKING

The compressor will normally be delivered with a polythene cover.
If a knife has to be used to remove this cover ensure that the exterior
paintwork of the compressor is not damaged.
Ensure that all transport and packing materials are discarded in a
manner prescribed by local codes.
NOTE
Units are shipped with transit locking bolt in place. Prior to running
the unit the shipping bolt must be removed and the belt tension
checked. Loosen, remove and discard 10mm shipping bolt. For belt
tensioning procedure refer to Maintenance section.
15