How To Install The Base Using The Latch System - Peg-Perego PRIMO VIAGGIO SIP ES 30.30 Owner's Manual

I - How to Install the Base Using the LATCH SYSTEM
Install the base with your vehicle parked
on level ground.
1• Take the car seat off the base by
moving the handle to the upright
position. Place your hand on the top
of the seat back and pull up on the
handle with your fingers.
Note: Pulling near the center of the
handle provides the easiest release.
2• Position the base rear facing in the
back seat of your vehicle. Check the
level indicator on the side of the
base to make sure that the pointer
is in the green area. If it is not, turn
the knob left or right until it is in the
correct position.
⇠ 14
PrimoViaggioSIP-ES_USA_30-30_FIU14 14 10-03-2010 14:44:49