How To Install The Base Using The Latch System - Peg-Perego PRIMO VIAGGIO 4.35 Owner's Manual

How to install the Base using the LATCH SYSTEM

Open the lockoff clip as shown
in the picture (a). Remove the
two anchor latches from their
housings. The latches are on
the side of the base. Remove the
adjuster from its support, loosen the latch
strap by pressing on the gray button and
pulling the strap as shown (b). Press the
red button on top of the latch connector
(c) and pull it out of its housing (d). Repeat
on the other side.
Push each latch onto the anchor bar
located between your vehicle seat
backrest and cushion. Press until you hear
a click (e).
- 26 -