How to install the Base using the UAS SYSTEM
Open the lockoff clip as shown
in the picture (a). Remove the
two anchor UAS from their
housings. The UAS connectors
are on the side of the base.
Remove the adjuster from its support,
loosen the UAS strap by pressing on
the gray button and pulling the strap as
shown (b). Press the red button on top of
the UAS connector (c) and pull it out of its
housing (d). Repeat on the other side.
Push each UAS onto the anchor bar located
between your vehicle seat backrest and
cushion. Press until you hear a click (e).
- 26 -