Ikco SAMAND Owner's Manual page 83

INDICATORS OF THE INSTRUMENT PANEL
Instant stop warning
Should this indicator lights on,
stop immediately and switch off the
engine. Contact with dealer or authorized
representative. The indicator light also
comes on to warn the engine oil pressure
3
and battery charge.
The indicator may also gets on to warn
the engine oil level is low or the engine
coolant temperature high
Warning
If the light comes on for any
reason, driver should stop the vehicle.
In case he continues driving, vehicle
owner will be responsible for any
resulted damages.
Warning of driver air bag
defect – orange
The indicator comes on when you start
the vehicle and blinks on for 6 times and
then should go out. In Case this light
stays on, it indicates there is a fault in
driver air bag system. You should refer to
authorized dealer as soon as possible, or
all responsibilities rest on owner.
82
CNG fuel position indicator
– Green*
The indicator turns on when CNG fuel
position activated.
If fuel consumption changes from gasoline
to CNG the indicator blinks.
Note
If CNG indicator is blinking continually and
gasoline mode is not converted to gas even
after warming up the engine; then there is a
fault in one part of CNG system and should
contact to an authenticated dealer. (for
details, refer to Starting and Driving - CNG )
Doors open- Red
This indicator shows that at least
one of the doors is opened. The indicator
operates even the engine off. Avoid driving
when the indicator on.
Driver safety belt - Red
By locking of the metal tongue of
the driver safety belt in the special buckle
and with a "click", we make sure of its
locking. With this action the indicator on
the panel is turned off.
* If equipped
Digital display screen guide
1
- When the ignition switch is turned to "ON" the
display shows odometer. odometer records the
total distance (km) the vehicle has been driven
since being delivered to the owner. The trip meter
could not be reset to zero (if it has been set on this
situation, otherwise it could be observed when the
ignition switch is in "OFF" position).
2- Trip meter indicates the distance (km) the
vehicle has been driven since it has been reset
to zero. Push reset button for 2 second to reset
the distance to zero.
3- This indicates the pressure of the gas in the
LCD and is made of 6 black stripes. When gas
pressure is full the 6 stripes are active and by
decreasing the gas pressure the number of
these stripes decreases. Gas tank insufficient
pressure warning is indicated by the flashing of
the first stripes in LCD. When the gas pressure
become zero the last stripes goes off.*