Windscreen Washer & Wiper - Ikco SAMAND Owner's Manual

Windscreen wiper / washer
The vehicle windscreen wipers\ washers
are controlled by the right side stalk, and
operate only the switch is on.
0- Off
1- Intermittent wipe (The interval between
two wipers depends on the speed of the
vehicle)
2- Normal speed wipe
3- High speed wipe
Caution
- In the very cold temperature, make sure the wiper blades are not frozen (the wipers motor
maybe damaged) .It's a good idea to clean or replace the wiper blade assembly on a regular
basis when they are worn out or whenever the efficiency of wipers are reduced.
- Always clean the windscreen In the event that you shut down the engine before the wiper blades
come to a standstill (0 positions), the wiper blades goes to zero status.
- When opening the bonnet, make sure the wiper blades are in 0 position (stop) position;
otherwise it will cause injury.
Single movement of wiper (Only
one reciprocating movement)
Press the stalk downwards only once, and
then release it to have a single wipe. The
windscreen wipers operate continuously
as well as pushing the lever.
WINDSCREEN WASHER & WIPER SYSTEM
Screen wash
Pull the stalk towards the steering wheel.
By pulling the lever each time, the screen
wipers operate three times. As long as the
stalk is pulled, the washers continue
working.
Soon after pulling the lever sprinkling will
start for 0.7 of seconds and the wipers will
start moving. As far as you keep the lever
sprinkling and washing will be continued
without cessation. But soon after leaving
the lever wipers will stop after 3 times of
moving . Three seconds, after cessation,
the 4th movement of will start for complete
cleaning of the glass.
3
* If equipped
101