Ikco SAMAND Owner's Manual page 60

Map reading light timer
Map reading light control comes on by
activating intelligent and operates in the
following situations:
1-While the vehicle is off and the vehicle
door or trunk is opened, this light turns on
and while the door is closed, the light stays
on for 12s and then turns off progressively.
2- When the vehicle is in theft deterrent
position, by pressing the unlock button,
light stays on; otherwise, it will be activated
by auto-lock and the map reading light
will turn off automatically.
3- In the case of danger and alarm, the
map reading light remains on till the end of
the theft-deterrent alarm position.
4- Should any of the vehicle's doors (such
as trunk lid and engine hood) are open,
when driving, roof light informs driver by
blinking.
How the background light turns
on and off?
Effective factors influencing on background
light turning on and off are as follow:
1- Alarm Position
2- Anti-Theft Position
3- L key
4- Front Light On/Off Position
5- On/Off Position
6- Keyboard keys (except L)
7- Messages display
Escorting of driver in darkness
When you're leaving the vehicle in dark
places ,you can keep the space alight for
30 seconds by turning on the small lights
and low light. For this purpose:
- Keep the switch in Stop position(or take
out the switch)
- Turn off the lights.
- Pull the indicator once towards yourself.
- Get out of the vehicle and lock it.
- small lights and low light will get on
automatically after 30 seconds and then will
get off again.
Automatic lock:
If the theft deterrent is activated, if the
"open" key is pressed on the remote
control, but none of the side doors, hood
door or trunk lid are opened within 12
seconds, the theft deterrent will lock
all side doors, hood door and trunk lid
automatically And the antitheft system will
be activated. After turning the engine on
and speeding up to 10 km/hour, doors will
be locked and unlocked after turning off
the switch.
Note:
In the event of failure of any one
of the keys (side doors, trunk or hood) or
shock sensor (if installed on the vehicle)
corresponding entry in the active state
of alarm is not checked and the situation
when activating the alarm Gyraz key to
activate the remote control with 4 times
flasher and siren* (the distance between
two consecutive) that is distinct from the
normal warning is given. In this case
it is necessary as soon as possible to
overcome the problem by referring to the
agency's action.
Car finder:
While the anti theft system is activated,
alarming* system gets activated once and
the flasher starts blinking for 15 seconds
by pressing the close key on remote
control.
Note:
1- Activation of alarming system ,means it
gets activated just for 0.020 second.
2- Activation of flasher ,means it gets
activated just for 400 milliseconds.
3- You can disconnect alarming system
by special switch delivered to you among
other keys of the vehicle.
ALARM
2
* If equipped
59