Audio Alarming On Insrtrument Panel - Ikco SAMAND Owner's Manual

INDICATORS OF THE INSTRUMENT PANEL
Direction indicators -
green
The directions of indicators
(turning to the right and turning to the left)
are defined by arrows. When you turn on
the left or right signals, the corresponding
green arrow on the instrument panel will
3
flash along with the respective turn signal
lights.
If the flasher (hazard warning light) is used,
both indicators flash together. If either
warning light flashes very rapidly, this means
that the corresponding direction indicator is
not operating.
Notice: This situation occurs only when
one of the front or rear direction lights
does not work properly, but if one of the
side lights is not working, it will have no
effect on the warning light flash frequency.
When you turn on the direction lights, lights
on folding mirrors will flash simultaneously
with related flasher*.
Important note: If the vehicle
experiences an excessive speed fall, the
alarm system automatically turns on the
flasher for 10 seconds.
This is a warning sign for excessive speed fall.
* If equipped
80
Headlamp dipped beam - Green
It lights up when using dipped
(dimmed) headlights
Headlamp main beam – Blue
It lights up when using main-
beam headlights
Front fog lamp – Green*
It lights up when using front fog lights.
Rear fog lamp – Orange
It lights up when using rear fog lights.
Low fuel level warning
Next to the fuel gauge there is a
warning light, when the light is on it shows
that less than 7 liters of fuel remains in the
fuel tank. Refuel as soon as possible.
Theft deterrent - red
It indicates that the theft deterrent
system is activated when blinking.
Engine diagnostic function –
Orange
This warning light comes on when the
engine performance tester finds any
problem in the engine. When the starter
switch is in second (ON) position, this
light comes on to indicate it is testing
performance of the engine and goes out
after engine being started. Should any
problem arise in engine during driving this
light comes on again.
Note:
- If the warning light comes on but the
vehicle functions are normal, you may
continue driving but should refer to an
authorized dealer.
- If the warning light comes on and the
vehicle functions are not normal, you may
not drive high speed and should refer to
an authorized dealer immediately.
- If the warning light blinks, it means
there is a problem in the ignition and
fueling system .In this case Make the
engine to work in low RPM and refer to
the authorized dealer of IKCO as soon as
possible.*
High coolant temperature
warning – red
This indicator is next to thermometer.
When the thermometer is on red position,
the indicator is on.
When the indicator is on stop immediately
(engine on) and refer to an authenticated
dealer. In the case of high temperature,
(STOP) indicator on.