Ikco SAMAND Owner's Manual page 153

CHANGING LAMPS
High mounted stop lamp
5
Lift the rear part of the light cover, and
pull it out of the rear shelf. Remove
the connector. Turn the bulb to reach
the holder four supporting screws. The
assembly should be completely replaced.
Refit the new assembly, and reconnect.
Before fitting the rear clamps, make sure
that front clamps are engaged.
* If installed in your car
152
Rear direction indicator / Brake
lamps
From inside the luggage compartment
press the two plastic longues to release
and remove the bulb holder. to release
and remove the lamp. Lamps have
bayonets. Push towards inside and turn
counter clockwise to remove.
Replace the lamp and refit the assembly.
Front fog lamp*
You can access the front fog tail through
beneath part of front set.
1-Unsrew the cover
2-Press in the spring clamps, and lift it up
to release
3-Remove the bulb, and disconnect the
connector
4-Fit the connector, and place the new
bulb without touching the bulb glass.
5-Align the bulb and the guide, and place
the spring clamps 6-Refit the cover
6- Screw the cover.