Ikco SAMAND Owner's Manual page 95

STARTING / DRIVING (CNG MODE)
Conversion from Gasoline to Gas*
While the engine is operating on the gasoline
mode, by pressing and releasing of fuel
conversion button, the corresponding indicator
on the instrument panel LED will start blinking
which denotes that the fuel conversion has not
3
taken place. After a while which depends on the
engine water temperature at the moment, the
conversion button is pressed down (e.g. under
the engine water temperature of 25 °C, this
time will be equal to 150 seconds, while under
higher temperatures the conversion time will be
shorter), the CNG indicator will stop blinking and
the light comes on permanently. This implies that
the fuel conversion has taken place completely.
Now the engine is working on CNG mode .
94
Warning
Do not change gear position for
braking on slippery roads
Never select the position "N" when
driving (if your vehicle is equipped
with automatic gearbox).
Never leave children unsupervised in
the vehicle.
Apply handbrake and select position
"P" when your vehicle is parked.
(if your vehicle is equipped with
automatic gearbox) – Do not park
your vehicle in places where there
is the risk of the contact of the hot
exhaust with flammable objects, such
as grass and/or dead leaves.
Note
In the event the engine REV is higher
than 4000 revolutions per minute and
it is accelerating up at the moment the
conversion button is pressed down,
the LED indicator will start blinking and
the engine will remain on CNG as long
as it has not left the REV domain, after
which it will convert to gasoline.
* If equipped