Rapid 2005 Installation, Operation & Service Manual page 71

Step 12.3.10
NOTE: Double-sided filter rails or filter
clips are not required for inlet hood with
moisture limiter.
Caulk the seams between the inlet hood and the air handler/filter section and on the open sides of the
J-bends that lock the roof panels together.
Step 12.3.11
Upper
Rail
Description
Drip Rail Upper Right
Drip Rail Upper Left
Drip Rail Lower Right
Drip Rail Lower Left
TEK Screw
For inlet hoods with permanent aluminum mesh filters, continue to Step 12.3.12.
For inlet hoods with birdscreen, no filters, the instructions end here.
For inlet hoods with moisture limiter, continue to Step 12.3.13.
Caulk
Lower
Rail
When attaching the drip rail, ensure that the drip rails are
positioned above the filter clips, using the provided holes in
the sidewall panels. Attach drip rail to right side of inlet hood
starting with the lower drip rail using five TEK self-tapping
screws. Attach the upper right side rail by sliding it inside the
lower drip rail where they overlap use five TEK self-tapping
Part No.
screws. Attach drip rail to left side of inlet hood starting with
13305092
the lower drip rail using five TEK self-tapping screws. Attach
13305093
the upper right side drip rail by sliding it inside the lower drip
13305094
rail where they overlap use five TEK self-tapping screws.
13305095
13404 Apply caulk to the drip rails before attaching to the side
panels.
Caulk
SECTION 12: I H
NLET OOD
61 of 147