Rapid 2005 Installation, Operation & Service Manual page 69

Step 12.3.7
Top Back Panel 1
Top Middle Panel 2
Attach top middle panel with five TEK self-tapping screws on
each side and with six 5/16-18 x 1 bolts, 5/16 washers and 5/16
flange nuts at the J-bend joint.
For Model 2020: Attach top back panel with five TEK self-
tapping screws on each side, seven TEK self-tapping screws to
the top mounting flange and with six 5/16-18 x 1 bolts, 5/16
washers and 5/16 flange nuts at the J-bend joint.
For Model 2030: Attach top back panel with five TEK self-
tapping screws on each side, nine TEK self-tapping screws to
the top mounting flange and with six 5/16-18 x 1 bolts, 5/16
washers and 5/16 flange nuts at the J-bend joint.
NOTE: Ensure that the side tabs of the roof panels are to the
outside of the side panels and that the J-bends interlock the
panel with the roof panel in front of it.
For inlet hoods with permanent aluminum mesh filters, continue to Step 12.3.9.
For inlet hoods with birdscreen, no filters, continue to Step 12.3.8.
For inlet hoods with moisture limiter, continue to Step 12.3.10.
SECTION 12: I
Description Part Number
Top Middle Panel #2 13205076 / 13305076
Top Back Panel #1 13205075 / 13305075
TEK Screw
5/16"-18 x 1 Bolt
5/16" Flat Washer
5/16" Nut Flange
H
NLET OOD
13404
20507
95211600
20509
59 of 147