Rapid 2005 Installation, Operation & Service Manual page 59

Step 12.2.6
Top Back Panel
J-Bend
Attach top back panel with four TEK self-
tapping screws on each side, with five TEK self-tapping
screws to the top attaching flange and with five 5/16-18 x 1
hex head cap screws, 5/16 washers and 5/16 flange nuts at
the J-bend joint. Ensure that the side tabs of the roof panel
are to the outside of the side panels and that the J-bend
interlocks with the front roof panel.
For inlet hoods with permanent aluminum mesh filters, continue to step 12.2.8.
For inlet hoods with birdscreen, no filters, continue to step 12.2.7.
For inlet hoods with moisture limiter, continue to step 12.2.9.
Step 12.2.7
Description
Horizontal mount for birdscreen
Screen
TEK Screw
Install horizontal mounting brackets for birdscreen on to face of inlet hood. Mount birdscreen with brackets
and secure with self tapping screws and washers.
Birdscreen
Horizontal Mount
Part Number
13505087
90740051
13404
Description
Top Back Panel
TEK Screw
5/16-18 x 1 Hex Head Cap Screw
5/16 Washer
5/16 Flange Nut
SIDE VIEW
SECTION 12: I H
NLET OOD
Part Number
13505075
13404
20507
95211600
20509
49 of 147