Rapid 2005 Installation, Operation & Service Manual page 42

B-S I , O
ERIES NSTALLATION PERATION AND
Step 11.2.3
Step 11.2.4
32 of 147
S M
ERVICE ANUAL
Header Panel
Description
Header Panel
Stiffner
TEK screw
Attach channels to end plate. Make
sure top channel is facing down and
bottom channels are facing up.
NOTE: Channels "open" to the
inside of the filter box.
Description
Channels
TEK screw
Attach header in between the lower
portion of the left and right side
panels.
Attach stiffener in between top
portion of left and right side panels.
Attach loose end of upper filter
Stiffener
channel to stiffener; attach loose
end of lower filter channels to
header piece.
On the inlet of the filter section,
rivnuts (P/N 91120106) are factory
installed. With additional 3/8"
hardware (P/N 20515 and
P/N 20517) the filter section can be
installed on the inlet of the unit. See
Page 43, Section 11.5 for additional
information on filter section
installation.
NOTE: For easier installation, the
filter section may be mounted to the
air handler at this point, prior to the
Part Number
77402.002[W]
addition of filters and access door.
77407.002[W]
Refer to Page 43, Figure 11.5 for
13404
installation instructions.
Part Number
77404.002
13404