Omcan IC-CN-0016 Instruction Manual page 19

TROUBLESHOOTING GUIDE
Problem
The machine doesn't operate.
The water doesn't feed in after the
ice maker starts.
The machine makes ice, but bin
does not fill up.
Water is leaking out of the unit.
Cubes are partially formed--are
white at the bottom.
Possible Cause
The ice maker is unplugged.
The fuse is blown.
The ice maker power switch turn to
OFF.
The ice storage bin is full of ice.
The water supply tap is turn off.
The water supply pipe is not
properly connected.
The condenser may be dirty.
The bin drain may be partially
restricted.
The air flow to the ice maker may
be obstructed.
The ambient temperature and
water temperature are high, or it is
near with some other heat source.
Some water drops to the floor
when you open the door to take
out ice from ice storage bin.
Water supply connection leaking.
Nut of the water drain hole leaking. Tighten fitting. See "Connecting
Drain pipe connection leaking.
Not enough water in the water bin.
19
Troubleshooting
Probable Correction
Plug in the ice maker.
Replace the fuse. Call for service
to check for a short circuit in the
ice maker.
Turn the ice maker power switch to
ON.
Take away the ice, make sure that
the ice-full sensor is free of ice.
Turn on the water supply tap.
Reconnect the water supply pipe.
Clean the condenser.
Clean out the drain, check the
installation.
Check the installation.
Check the installation.
Normal condensation on the door
or some water together with ice.
Take care when you take out ice.
Tighten fitting. See "Connecting
the Water Line".
the Water Line".
Tighten fitting. See "Connecting
the Drain".
Check if the water supply pressure
is below 15psi.
Check water supply--filter may be
restricted.
Check for a water leak at the water
bin.
Check water inlet valve may be
restricted.