Operation; Basic Status - marklin bauzug-geratewagens User Manual

Operation

The following work sound effects or visual effects can be selected with this
sound effects circuit:
1 Yellow warning light blinks in the car.
2 Different random sounds are reproduced. Yellow warning light blinks.
Flickering welding light is not reproduced.
3 Same as 2 but without the blinking warning light. Flickering welding
light with appropriate work sounds.
4 Work sounds of a vibrator/stamp hammer.
5 Work sounds of a compressed air screw driver with compressor.
6 Work sounds of a welding rig.
Also, flickering welding light in the car.
7 Work sounds of a grinding wheel.
8 Work sounds of hammering.
9 Work sounds of a compressed air screw driver.
10 Work sounds of metal being bended.
11 Work sounds of a metal saw.
12

Basic Status

The work sound effect 1 is called up
in the electronic circuit's basic state
(blinking warning light). All of the fun-
ctions of the sound effects circuit are
turned off. This basic state is reached
when the sound effects circuit itself if
without power for a short time.
Calling Up the Sound Effects
Circuit
A digital locomotive controller
(Control Unit, Control 80 f) is required
to operate the sound effects circuit.
First, enter a two-digit digital address
on the ten button keypad on the
locomotive controller, just as you
would for calling up a locomotive.
The digital address set at the factory
for the sound effects circuit is 21.
With the Mobile Station you must
configure the equipment car as one
of the 10 possible entries in the loco-
motive list. The exact procedure for
this can be found in the instructions
for operating the Mobile Station.