Valve Stem Outside Diameter And Valve Guide Inside Diameter - Measure; Valve Guide - Replace - Mitsubishi S12A2 Service Manual

Chapter 6 INSPECTION AND REPAIR OF BASIC ENGINE

1.3 Valve Stem Outside Diameter and Valve Guide Inside Diameter - Measure

Measure the outside diameter of valve stem and the inside
diameter of valve guide at the top and bottom sliding ends in
right-angle directions as shown, as the sliding surface tends
to wear at the top and bottom ends.If the measurement
exceeds the limit, replace the valve guide or valve with a
new one.
Note: Lap the valve and valve seat whenever new valve is in-
stalled.
Nominal
Item
value
ø10 mm
Inlet
[0.39 in.]
Valve stem
outside diam-
eter
ø10 mm
Exhaust
[0.39 in.]
Valve guide inside diam- ø10 mm
eter [0.39 in.]

1.4 Valve Guide - Replace

Be sure to use the guide and seal installer, and press-
in the valve guide to the specified height.
(1) Remove the valve guide with valve guide remover.
(2) With guide and seal installer, press-in the new valve
guide slowly.
6-4
Standard
Limit value
value
9.940 to
9.960 mm 9.910 mm
[0.0010 to [0.3902 in.]
0.0044 in.]
9.910 to
9.930 mm 9.880 mm
[0.3902 to [0.3890 in.]
0.3909 in.]
10.000 to
10.015 mm 10.060 mm
[0.3937 to [0.3961 in.]
0.3943 in.]
Valve Stem Outside Diameter - Measure
Valve Guide Inside Diameter - Measure
Valve guide
remover
P/N:36291-04200
Valve Guide - Remove
27.5 27.5 ± 0.1 27.5 ± 0.1 ± 0.1 mm mm mm
[1.083 ± 0.004 in.] [1.083 [1.083 ± 0.004 in.] 0.004 in.]
Valve Guide - Press-In
Measurement
direction
Measurement
point
Measurement
direction
Measurement
point
Guide & seal installer
P/N:32591-10300
Valve guide
Cylinder head