Charging The Phone And The Battery - Cisco 7920 User Manual

Locking catch. Press the catch to release the
1
battery.
Catches to be inserted into the corresponding
2
slots near the bottom of the Cisco Wireless IP
Phone 7920 at battery installation.
Metal contacts.
3
2. Press the battery to the body of the phone until it
locks into place.
3. To remove the battery, press down on the locking
catch of the battery. Then lift and remove the
battery.

Charging the Phone and the Battery

The Cisco Wireless IP Phone 7920 is powered by a
rechargeable battery. To charge the battery when it is
installed in the phone, follow these steps:
1. Connect the cable from the power supply to the
base of the phone.
2. Connect the power supply to an AC wall outlet as
shown in Figure 2-2.
Cisco Wireless IP Phone 7920 User Guide
Getting Started
17