Morgana DigiCreaser Operator's Manual page 9

DigiCreaser
Move the selection switch to the left to select the
6.
select Decimals
can then be adjusted by rotating the Selection Switch, (clockwise to
increase or anti-clockwise to decrease).
7. To set the 2nd Crease position move the selection switch down; the 2nd
Crease is selected and can be set as described in step 6. Above
8. Further creases can be set in this way, up to a maximum of nine
creases.
9. When the required creases have been set, move the selection switch up
step by step until the display contains the word
Move the selection switch to the right to select
10.
11.
Move the selection switch to the right again to select
12. Move the selection switch up or down to select
13. Move the selection switch to the right to select
14. Move the selection switch up step by step until the display contains the
word Feed .
Press the System Switch down, the display will momentarily read Please
15.
Wait Initiating
16.
Move the selection switch down to select
individually into the rollers.
17.
When the sheets have been fed into the machine and creased; move the
selection switch up, to select
Switch up to stop the machine.
SYSTEM
Quick Start Guide
. The Tens or Decimals
Set Creases
Tens
( 2nd Crease
3rd Crease
Tools
2 Creases
and then return to show
Stop Feeding
Tens
(whichever has been selected)
Back
Decimals
000.0 )
0.0
Feed
Setup
Feed
Zero
Total 20
Program 3
Setup
High Speed
Ok .
High Speed
Feed , and feed the sheets
, and then press the System
, or to the right to
, see below.
.
More .
or Low Speed
or Low Speed.
Page 9
.