Spares - Morgana DigiCreaser Operator's Manual

DigiCreaser
FIG 21.1
11. Push the exit guard down and replace the stacker assembly before operating the
machine.
12. Switch the machine on and test the crease for form.
If the pressure and the alignment of the crease is not to a satisfactory level,
see pages 19 –20 to adjust the creasing line.
'Spares' kits
In the event of any damaged or lost components within the blade assembly, spares kits
are available on request. However, components within the blade set can not be ordered
separately ie single blade or anvil.
Standard Blade set
Consisting of a standard blade and anvil, blade brushes, blade links and alignment bolts.
SYSTEM
Replacing Blade Set
Part number 76-213-01
Page 21