Reading Stored Programmes; Paper Jamming - Morgana DigiCreaser Operator's Manual

Setting the Speed (High Speed or Low Speed)
4. (i) Move the selection switch to the right to select
(ii) Move the selection switch to the right again to select
(iii) Move the selection switch up or down to select
(iv) Move the selection switch to the right to select
(v) Move the selection switch up, step by step, until the display contains the
word Feed
Running the machine
5. To run the job with the selected settings.
(i) Press the System Switch down, the display will momentarily read Please Wait
Initiating and then return to show
(ii) Move the selection switch down to select
into the rollers.
(iii) When the sheets have been fed into the machine and creased; move the
selection switch up, to select
up to stop the machine.
Reading stored programs
Any of the nine stored programs can be accessed and read as follows:-
(i) From the start up menu, move the selection switch to the right to select
(ii) Move the selection switch to the right, one click at a time, until the display contains
the word Program
(iii) Move the selection switch down to select,
( v) Move the selection switch to the right to select, i
(v) Move the selection switch to the right or to the left to select,
(vi) Move the selection switch up to select,
(vii) Move the selection switch up again to select,
The details of the selected program can now be viewed or edited.

Paper jamming

In the event of a paper jam occurring whilst the machine is operating the display will
read Paper Jam. In order to remove the paper causing the jam, move the selection switch
to the left or to the right to drive the paper forwards or backwards in short pulses.
Page 12
Operating the Digicreaser
.
Stop Feeding
.
Setup .
More
High Speed
Ok .
High Speed or Low Speed
Feed , and feed the sheets individually
, and then press the System Switch
Select Retrieve Settings
Ok .
Load .
Ok .
HAND FED CREASING
.
or Low Speed .
.
Setup .
.
Program 1 to Program 9 .