Rotate The User Interface On The Transmitter (Optional) - Emerson Micro Motion 1700 Installation Manual

2.3 Rotate the user interface on the transmitter
(optional)
The user interface on the transmitter electronics module can be rotated 90º or 180° from
the original position.
Figure 2-2:
A.
B.
C.
D.
E.
F.
G.
Notes
•
•
Procedure
1.
2.
3.
4.
5.
Installation Manual
Display components
A
B
Transmitter housing
Sub-bezel
Display module
Display screws
End-cap clamp
Cap screw
Display cover
When using the touch buttons, you must cover at least an 8 mm diameter circle over the
surface above the touch button: using your thumb may be more effective because it has a
greater surface area.
When the housing cover is removed, the touch buttons do not function.
Shut off power to the unit.
Remove the end-cap clamp by removing the cap screw.
Turn the display cover counterclockwise to remove it from the main enclosure.
Carefully loosen (and remove if necessary) the semicaptive display screws while
holding the display module in place.
Carefully pull the display module out of the main enclosure until the sub-bezel pin
terminals are disengaged from the display module.
Mounting and sensor wiring for integral installations
C
D
G
E
F
13