Rotate The User Interface On The Transmitter (Optional) - Emerson Micro Motion 5700 Installation Manual

Mounting and sensor wiring
May 2019
3.6 Rotate the user interface on the transmitter
(optional)
The user interface on the transmitter electronics module can be rotated 90°, 180°, or 270°
from the original position.
Figure 3-12: Display components
A. Transmitter housing
B. Sub-bezel
C. Display module
D. Display screws
E. End-cap clamp
F. Cap screw
G. Display cover
Procedure
1. Shut off power to the unit.
2. Loosen and rotate the end cap clamp so that it does not interfere with the cover.
3. Turn the display cover counterclockwise to remove it from the main enclosure.
4. Carefully loosen the captive display screws while holding the display module in
5. Carefully pull the display module out of the main enclosure.
6. Rotate the display module to the desired position.
20
WARNING
If the transmitter is in a hazardous area, wait five minutes after disconnecting the
power before opening the enclosure.
place.
Micro Motion 5700 transmitters with Intrinsically Safe Outputs
Installation Manual
MMI-20039473