Installing And Replacing Cordless Handset Batteries; Note - Cisco SPA302D Owner's Manual

15. If screen does not illuminate verify batteries are installed
correctly and repeat steps 11-12 before moving to next step.

Installing and Replacing Cordless Handset Batteries

Each Cordless Handset purchased from Intermedia will come
with batteries pre-installed. Batteries must be charged for 10
hours prior to first use. Use the following instructions to verify
batteries are correctly installed or when replacing.
Rechargeable batteries must be replaced periodically to retain a
charge.

Note

Defect or exhausted batteries should never be disposed of as
municipal waste. Return old batteries a licensed battery dealer or
a designated collection facility. Do not incinerate batteries.
WARNING
Use only size AAA Ni-MH 800 mAh (1.2V) rechargeable batteries
in the Cisco SPA302D Handset. Place the Handset in the
charging cradle for a recommended initial charge of 10 hours
before using the Handset for the first time.
WARNING
1. Slide Handset battery cover and remove.
2. Place AAA Ni-MH 800 mAh (1.2V) rechargeable batteries into
the Handset per the label inside the battery compartment.
3. Replace the Handset battery cover by sliding on.
16
Owner's Manual