Warning - Cisco SPA302D Owner's Manual

8. Insert the power clip into the power adapter.
9. Insert the power adapter into the power source or wall outlet.
10. Connect the power adapter to the charging cradle in the port
shown below.
Only use the 1Amp power adapter designed for use with
Cisco Cordless Handset SPA300 Series devices.DO NOT
USE THE POWER ADPATER FOR THE CISCO CORDLESS
BASE

WARNING

11. Place the handset into the charging cradle. The light on the
charging cradle appears solid green when the handset is
charging.
Charge the Handset for a minimum of 10 hours before using the
Handset for the first time to ensure that the Handset is fully
charged
Note
12. After handset is fully charged or while the handset is in the
cradle do the following.
13. On the Cisco Cordless Handset, press and hold the End Call.
button for 5 seconds.
14. Release the End Call button and wait up to 10
seconds for the screen to illuminate.
Owner's Manual
15