Important Safety Information - Roundup VCT-1000 Owner's Manual

Vertical contact toaster
impOrtant safety infOrmatiOn (continued)
in addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the
unit.
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with
a properly grounded cord connector. Do NOT
attempt to defeat the grounded connector.
• Install or locate the equipment only for its intend-
ed use as described in this manual. Do NOT use
corrosive chemicals in this equipment.
• Do NOT operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or
if it has been damaged or dropped.
• This equipment should be serviced by qualified
personnel only. contact the nearest Roundup
Authorized service Agency for adjustment or
repair.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
the following warnings and cautions appear throughout
this manual and should be carefully observed.
• Turn the power off, unplug the power cord, and
allow unit to cool down before performing any
service or maintenance.
• The procedures in this chapter may include
the use of chemical products. these chemical
products will be highlighted with bold face let-
ters followed by the abbreviated Hcs (Hazard
communication standard). see Hazard
communication standard manual for the appro-
priated Material Safety Data Sheets (MSDS).
• The toaster should be grounded according to
local electrical codes to prevent the possibility of
electrical shock. it requires a grounded recep-
tacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. failure to maintain safe
operating distances may cause discoloration or
combustion.
• Failure to use Release Sheets may result in
damage to the equipment and loss of warranty
coverage.
• All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
• WARNINg elecTRIcAl ShOcK hAzARD.
fAiLuRe tO fOLLOW tHese iNstRuctiONs
cOulD ReSulT IN SeRIOuS INjuRy OR
DeATh.
- electrical ground is required on this appliance.
- Do NOT modify the power supply cord plug.
if it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
- Do NOT use an extension cord with this
appliance.
- check with a qualified electrician if you are
unsure if the appliance is properly grounded.
- if the power cord is damaged, it must be
replaced with a power cord available from
the manufacturer or an Authorized service
Agency.
4
P/N 1010930 Rev. A 06/08