Table of Contents
Advertisement
1.2 Hardware Installation
The hardware installation for the VC-2402 is simple and without complex hardware
setting. However, it should be installed following out the standard installation
procedures. During installation, basic safety precaution should always be taken,
especially, be sure to wear an antistatic wrist strap to prevent static electricity from
damaging the system and injury to the operator. Handle electronic components as
little as possible.
This chapter provides the VC-2402 system hardware installation procedures and
install samples for reference. Please perform the procedures in the suggested
order.
1.2.1 Hardware Type
There are two different types of VC-2402 hardware with the front panel view:
1.2.2 Installation Overview
The installation consists of the following procedures. Each procedure will be
explained in detail in the following sections:
Step 1: Mount the system into the desired location of a rack.
Step 2: Turn the power switch in OFF position. Connect to the DC power supply,
and then check the voltage. Make sure the power switch is in OFF position
before wiring the power cable and grounding.
Step 3: Connect the cable between system and MDF.
After executing the previous procedures, please check the cable connection
robustness and correctness before turning on the power supply.
VC-2402-48 with DC power and splitter
VC-2402 with AC power and splitter
Advertisement
Table of Contents
