Table of Contents
Advertisement
1. Installation of the VC-2402
1.1 Pre-Installation
This section provides the information users have to ware before installing the VC-
2402. The information includes required installation tools, safety requirements, and
electrostatic discharge protection.
1.1.1 Tools and Test Equipment Requirements
To install and maintain the VC-2402, you should have the tools and test equipment
listed in the Table 1-1.
Table 1-1
Required Installation Tools and Materials
Item Required
Anti-static wrist strap
Hand tools
Wire cutter/stripper
Accessories and hardware kit
1.1.2 Safety Requirement
To prevent possible serious injury, do not apply power to the VC-2402 system at
the central office or any remote site until you've completed all of the installation
procedures and connected it to the external facilities. Be cautious, when turning
on/off the VC-2402 system power.
1.1.3 Electrostatic Discharge Protection
The terminal cards contain static-sensitive components. When handling them, be
sure to wear a properly grounded anti-static wrist strap to prevent the damage
from electrostatic discharge. If a wrist strap is not available, hold all cards only
by their edges or extractor handles. Do not touch any component or traces on
the cards. For future use, store cards in original shipped antistatic bags, or in an
approved static-protected bag or container.
To minimize the possible damage from electrostatic discharge, do not install the VC-
2402 in cold, dry places where static electricity can build up. Also, when handling
cards, do not touch their rear-edge connector traces. These electrical contact points
should be kept free of body oils and other contaminants.
Purpose
Protect the VC-2402 system from electrostatic
discharge damage.
Screw drivers for equipment removal and
replacement.
Prepare wires for electrical connections.
Screws, bolts, etc., for securing the equipment
on the desired location.
Advertisement
Table of Contents
