Planet VC24024 Quick Installaion Manual page 25

localhost:>enable
localhost:%configure
localhost:(conf)#firmware write <FTP server ip address> <username> <password>
<filename> {image|bootloader} [noreboot]
//get files from FTP server and write to FLASH.
// The word "noreboot" in this command is optional. If you add it in the command, you must
reboot the system manually for the changes to take effect; otherwise the system will reboot
automatically once the firmware/bootloader is updated.
Description
Perform software image or bootloader remote download.
Syntax
firmware write <ip> <username> <password> <string> {image | bootloader} [noreboot]
Parameter Name
<ip>
<username>
<password>
<string>
image
bootloader
noreboot
Note: Getting file from FTP Server and writing to Flash ROM needs several minutes; you can get latest status by
using command 'show firmware status'. During the Flash writing process, you MUST NOT turn off or reset
the system.
5. After system restarts, login the CLI again and use the 'show firmware partition'
or 'show bootloader' command to check if the software upgrade is successful.
In Web:
Please refer to VC-2402 User's Manual.
2
//go to enable mode
//go to configuration mode
Description
FTP server IP addres
Type: Mandatory
Username
Valid values: 1 ~ 31 characters
Type: Mandatory
Password
Valid values: 0 ~ 31 characters
Type: Mandatory
Image path and filename
Valid values: 1 ~ 64 characters
Type: Mandatory
Perform remote download for the software image
Type: Mandatory
Perform remote download for the bootloader
Type: Mandatory
No Reboot after command commplete.
Must reboot system manually for the changes to take effect!
Type: Optional