Table of Contents
Advertisement
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the
recommended separation distanced in meters (m) can be estimated
using the equation applicable to the frequency of the transmitter, where P
is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher
frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reflection from structures,
objects and people.
Guidance and manufacturer's declaration – electromagnetic
immunity
The model WMP-19B/22B is intended for use in the electromagnetic
environment specified below. The customer or the user of the model
WMP-19B/22B should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
8
0,38
IEC 60601
test level
6 kV contact
8 kV air
2 kV for
power
supply lines
1 kV for
input/output
lines
WMP-19B/22B User's manual
1,2
3,8
12
Compliance
level
6 kV contact
8 kV air
2 kV for
power
supply lines
1 kV for
input/output
lines
0,38
1,2
3,8
12
Electromagnetic
environment –
guidance
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material, the
relative humidity
should be at least 30
%.
Mains power quality
should be that of a
typical commercial or
hospital environment.
0,73
2,3
7,3
23
Advertisement
Table of Contents
