Table of Contents
Advertisement
Repeat the procedure with
the
and
buttons and OK
to program the exact timer
for stopping a Timer
To program a [SINGLE DATE]
Timer...
Press to display the date you
or
want to program a Timer for
then
Press to accept the selection
then
Press to store your Timer
programming and return to
normal source operations
Checking or clearing Timers
Press to check your timers
then
Press to see timer program-
or
ming number, source and
program number of
individual timer entries
Press repeatedly to display
the details of a particular
programming
When the display reads [OK ?]
then
Press to display [NEXT ?] to
or
see your next timer program-
ming entry
then
Press to see your next entry –
If there are no more entries,
[NO MORE], will appear on
the display
Press clear while information
regarding a timer program-
ming is displayed on the
display – [CLEARED] will
appear on the display after
pressing CLEAR
Setting and using the built-in
clock
Press to call up the built-in
clock
then
Press to set time, date/month
or
or year...
then
Press to accept the changes
and reveal the next display -
Repeat this setting
procedure for date/month
and year...
When you have set or
changed the year, the
display now reads [CLOCK
OK?]
then
Press to store your new
setting of the clock
Press to show the clock
Press to see the date and
year
To display the clock
permanently...
Press when Date and Year is
displayed and change the
display to time and ON e.g.
[14:40 ON] – press again to
cancel the permanent
showing of the clock e.g.
[14:41 OFF].
Option programming Beo4
hold
while pressing
Until the Beo4 display reads
OPTIONS?
then
Until the display reads A:OPT
then
Disable the remote control
function
or
Enable the remote control
function
Option programming
BeoLink 1000
Disable the remote control
function
or
Enable the remote control
function
Centering the CD drive mechanism
The sledge must be in
position 1.
Centered for a flat or near
flat position. This is the
factory setup.
Brief operation guide
Automatic demonstration
The product can be brought into
automatic demonstration mode in which
it plays back 90 randomly chosen tracks.
Each track is played back for 20 seconds.
Load six CD's with at least ten tracks each.
Bring the product into stand-by.
Press: SHIFT 9 1 9 9 6.
The remote control terminal must be in
audio mode.
(SHIFT is found under LIST on Beo4)
The automatic demonstration can be
stopped by bringing BeoSound 9000 into
stand-by, which is done by actuating
stand-by on the product.
During the automatic demonstration the
sound will be muted. Demute the product
if you want sound.
Locking of glass lid
The glass lid can be locked so that it
cannot be operated on the product.
Press: SHIFT 9 0 3 6 9.
The remote control terminal must be in
audio mode.
The display reads: LOCK.
The function is stopped by pressing:
SHIFT 9 0 3 6 9.
The remote control terminal must be in
audio mode.
SHIFT is found under LIST on Beo4
The display reads: UNLOCK.
Centered for a horizontal position.
Used for the bracket type 2054.
1.7
Centered for a
horizontal position.
Used for the bracket
type 2053.
Centered for a vertical
position.
Advertisement
Table of Contents
